In order to replace final test points, so you have to make into a group each consist of 3 person. Each group must accomplish this final assignment below :

• Design and implement in a single board a Minimum System using ARM based processor STM32F103RET6 as schematics given bellow (You can use Altium or other electronics designer software)

Minimum System Design

USB to TTL Design

• Make a simple program to show how the I/O work using Eclipse Indigo IDE C/C++ (there are must be differences between a group to others – can use different I/O)
• Make a report maximum in 5 pages, consist of introduction, design and implementation, measurement and testing, conclusion
• Each group must give presentation and show the demo to the lecturer between December 7th — 17th, 2014 at N205 (Embedded System Laboratory)

 

Note :

You can also search many tutorial in the internet, forum, and other resource to accomplish this project. You are also permitted to use other schematics, but still using STMicroelectronic. If there’s any question, you can leave comments here.

 

I hope all of you can finish this and all of the minimum system can be used and demonstrated.

Thanks and Good Luck